Your visor! For me this was the hardest part since no matter what I did, it didn’t Later, since the visor will be in the way then. If you want to use a finisher I recommend you to do that now instead of Over the night and paint the thing yellow on the morning either by spray orīrush. Since I was lazy again I simply spray painted a layer of white on the outsideĪnd the visible parts on the inside. Not necessary, but I like to think that it’s easier to paint since the clay won’tĪbsorb the paint in the same way anymore. First I glued the foam pieces on, let them dry,Ĭut them into the right shape, cowered them in wood glue in order to fill the tinyĪir holes in the foam, then finally two layers of clay on to get the wholeīase smooth and the second to get the correct shape.Īll this was done I cowered the whole thing with diluted wood glue. Sure what to call the ear-muff looking things on the side of the head, buuut I Magnets on mine, I just made four craters big enough for the magnets and horns. Magnet or something else) or if you want permanent ones. Same goes for the “holes” where your hornsĪre, which makes it time for you to decide if you want removable horns (with a You want the front part to come down like in the talksprite, you can add that Let theĬlay dry for the day and then sand it smooth. Smoothed the clay on both sides so the clay had more to hold on to. This and hoped that once dry it would stay where I put it, which it thankfully I used a light weight air drying clay for REMEMBER that there is going to be a new padding as well as a wig under there It was just to reassemble the thing again and choosing what size to have, Holes where the screws and bolts once were in order to remove rough edges. I finally had the helmet in two pieces without padding, I sanded a bit on the Sawing, now is the time to bring it out together with the screwdriver, you’re If you own a jeweler saw or another saw that can hold thin blades for metal The only way for me to remove it was to saw the bolts holding it in place off. The padding turned out to sit extremely hard and Step since I didn’t want my helm to look bulky was to dismantle the whole damn I actually found that in the Reebok 3K Hockey Helmet, so now I had my base! Had to find one with my wanted features already on it. I’m a lazy bum I didn’t want to add too much extra build to the helmet, so I Since the talksprite’s helmet doesn’t look completely smooth and I prefer it Important feature on the helmet for me was Pictures with most of the helmet already assembled, so I’m mostly going toĭescribe what I’ve done and point on pictures. Progress during the whole work, and I’m not even joking! I have about two Tutorial of it? Unfortunately I was really extremely bad at taking photo Had a couple of people asking how I made my Mituna helmet, so why not make a

Mituna captor talksprite